I’m using oxi one and sometimes Pam’s workout, both can put out 24ppqn. Are you saying your not able to get specific bpms, just 300, 150 and 75? I would have trouble not being able to define a range of bpms. Maybe see if you can clock with an lfo?Most often my master clock in that case is After Later’s Steps, sometimes I clock SB with a Wogglebug in another case. I don't have a clock that sends pulse divisions, and after 300 bpm both Steps and the Wogglebug become less usefull to me as burst generators or random step cv sources.I’m curious about your max 4ppq you are sending, what are you clocking with? I also send 24ppqThank you for this respectful response. You have been very helpful.
I'm not on their discord server so I cannot check in there, so again, thanks for letting me know what's going on with the new firmware build.
I work in BPM for my master clock, and 1, 2 or 4ppqn are settings I might have on SB to divide that incoming clock. A setting of 4ppqn puts SB at 75 BPM when dividing a 300bpm external clock. A setting of 8ppqn would put SB at +/-37.5bpm with the same external clock, and after that the ppqn divisions are unusable as the module will not respond to further divisions and starts to ignore the incoming clock.
As stated before, I often feel both Steps and the Wogglebug become less useful at (what I would consider) faster clock speeds so I usually have it in the 120-180bpm range or slower. This rarely allows me to set SB to anything higher than 2ppqn.
What clock source do you use with SB?
https://modulargrid.net/e/after-later-audio-steps
Statistics: Posted by ekkomouse — Sat Jun 15, 2024 7:03 pm