I'm afraid my bend assembly is unreliable. It's been serviced and modified so that the bend pot isn't attached by screws but glued to the top of the assembly. During the calibration process I noticed that the CV seldom goes back to 0V after moving the lever. It sometimes stops at 0,008, sometimes at -0,007, sometimes at 0,011, sometimes at -0,004, sometimes very far away...
Is there by the way any reason to do the sound card calibration with the octave switch in down position?
I don't really plan to utilize the lower octave on this instrument so it would feel more appropriate to do the tuning process with the octave switch in it's default position
Is there by the way any reason to do the sound card calibration with the octave switch in down position?
I don't really plan to utilize the lower octave on this instrument so it would feel more appropriate to do the tuning process with the octave switch in it's default position
Statistics: Posted by BigTom72 — Mon May 27, 2024 3:29 pm